Sybase 15 - Manual (Page 34)

Pre-installation tasks
22 Replication Server
Before you install Replication Server, decide which SySAM configuration to
use:
• Unserved model using unserved licenses
• Network license server using Served licenses
If you are going to use a network license server, decide whether to use an
existing license server or a new license server.
• If you use an existing license server, you must know the server host
name and port number.
• To create a new license server before installing Replication Server,
see “Installing a new license server” on page 22.
Note Sybase recommends that you obtain the license files from the Sybase
Product Download Center (SPDC) at https://sybase.subscribenet.com before you
begin installation.
Installing a new license server
Perform the following steps to install a new license server on a machine
separate from the Replication Server you want to run:
1 Mount the CD by running the following command:
• HP-UX
Enter the following where device_name is the name of the CD device
drive, and /RS150HP/cdrom is the name of the directory where the
CD is to be mounted:
/etc/mount -F cdfs -o ro device_name /RS150HP/cdrom
• IBM AIX
Enter the following where device_name is the name of the CD device
drive, and /RS150IBM/cdrom is the name of the directory where the
CD is to be mounted:
/usr/sbin/mount -v 'cdrfs' -r device_name /RS150IBM/cdrom
The location of the mount command is site-specific and may differ
from what is shown in these instructions.
• Solaris
The operating system mounts the CD automatically.