Livarno Halogen Under-Cupboard Light - Manual (Page 41)

41 GB
Preparation for use / Operation
the mains socket, otherwise damage to the product
may occur.
Note: Ensure that no more than 3 under-unit lights
of the same type are connected together in series.
Note: If you install and connect the lights in series
(max. 3 No.), they function independently of one
another.
j Install up to three lights of the same type close to
one another. Follow steps 1 to 6 of the section
on “Installing the light”.
Note: Ensure that the distance between the
lights is not greater than 20 cm.
j Remove the protective cap from the connection
socket
8 by screwing out the screws anticlock-
wise using a Phillips screwdriver.
j Plug the connection cable 14 into the connec-
tion socket 8 of the light.
j Plug the other end of the connection cable 14
into the light connector socket 6 of the other
light.
j Insert the connector plug of the mains lead 5
into the light connector socket 6 of the outer
right light.
j Insert the mains plug 5 into the mains socket.
Your lights are now ready for operation.
Q
Operation
Q
Switching the light on / off
Note: The under-unit light can be operated with a
toggle switch
12 as well as a motion sensor 7 .
The toggle switch has the following
functions:
- Toggle switch in position
0: Light and motion
sensor are switched off.
- Toggle switch in position 1: Light switched on,
motion sensor deactivated.
- Toggle switch in position 2: Motion sensor
activated. The light only is only switched on
by the motion sensor.
Q Adjusting the motion sensor
Note: The motion sensor is fitted with a twilight
sensor. You can set the sensitivity of the twilight
sensor with the day / night control LUX
10 and the
lighting period with the time control TIME 9 .
Setting the light sensitivity:
j Turn the day / night control LUX 10 anticlock-
wise to increase the light sensitivity (motion
sensor
7 reacts at a darker stage of twilight).
j Turn the day / night control LUX 10 clockwise
to reduce the light sensitivity (motion sensor 7
reacts at lighter stage of twilight).
Setting the lighting period:
j Turn the time control TIME 9 anticlockwise to
shorten the lighting period (min. 20 s).
j Turn the time control TIME 9 clockwise to
lengthen the lighting period (max. 6 Min.).
Note: The motion sensor 7 of the under-unit light
reacts to heat. As the room temperature rises the
sensitivity of the motion sensor reduces (takes longer
to react).
Q
Replacing a bulb
RISK OF ELECTRIC SHOCK!
To replace the bulb 13 , first of all disconnect the
light from the mains circuit. Pull the mains plug of
the mains lead
5 out of the mains socket.
CAUTION! RISK OF BURNS! Let the bulbs
13 cool down fully before you replace them.
j Turn the cover 11 anticlockwise and take it off.
j Draw the defective bulb 13 in the direction of
the arrow out of the fitting socket (see Fig. B).
Note: Use only a halogen bulb type G4
12 volt with a maximum rated power of 20 W.
Note: Use a soft, fluff-free cloth when you are
replacing a bulb
13 . Never touch the bulb 13
with your bare hands.
j Insert a new bulb 13 into the fitting socket.
j Put the cover 11 back in place and turn it
clockwise to tighten it.