Emerson Radio ES128 - Manual (Page 15)

14
Listening To The Radio
1.) Press the POWER button on the main unit or remote control to turn the
system ‘On’. The Standby indicator goes off.
If necessary, press the FUNCTION button to
select the Radio mode and the display shows:
FM 87.5 MHz.
To switch between FM and AM bands press the
BAND button on the front panel or remote.
2.) Tune to the desired station as follows:
• Automatic Tuning - Depress and hold the or buttons until the display
begins to move, then release the buttons. The tuner will scan up or down the
band until it finds the first strong station, and then stop on that station. Repeat
this process until the tuner stops on your desired station.
If you tune to an FM Stereo station the “(ST)”
indicator appears in the display.
• Manual Tuning - Press the or buttons repeatedly until the display is
showing the frequency of your desired station. Use the manual tuning method
to tune to weaker stations that are bypassed during Automatic Tuning.
3.) Press the VOLUME or buttons to adjust the volume to the desired level.
4.) When you are finished listening press the POWER button to shut the system
‘Off’. The main display lighting goes off, the Standby indicator comes on, and
the display returns to the correct time.
Last Station Memory
The system remembers the last station you were listening to before the power is
switched off and automatically returns to that same station when the power is
switched on again.
ES128_042806.p65 28/4/2006, 11:39 14