Electrolux 50620 - Manual (Page 19)

Operating Instructions
19
Performing a Washing Cycle
Brief Instructions
A washing cycle is performed in the following steps:
0
1. Check whether the water tap is opened.
2. Open the door, load the washing.
3. Close the door.
4. Add detergent/conditioner.
5. Set the correct washing program:
– Set the program on the program selector;
– Set the temperature on the temperature selector;
– In the case of easy-care washing: Press the EASY-CARES button.
6. Press the ON/OFF button.
The washing machine is switched on. The washing program starts.
7. If necessary, change the spin speed or select rinse hold.
You can alter this setting and the temperature during the entire
washing cycle.
When the Washing Program has Finished:
Important! If the washing cycle ended with rinse hold, carry out a
PUMP OUT, SPIN or SHORT SPIN before opening the door.
3
For safety reasons, the door remains locked for 1-2 minutes after the
end of the program.
8. Open the door, remove the washing.
9. Press the ON/OFF button.
The washing machine is switched off.
10. Close the water tap.
We recommend you unplug the appliance and turn off the water
supply when the washing program has finished.