Florabest FGPS 1100 B2 - Manual (Page 17)

17
MT GB
motor fuels) or explosive liquids, salt
water, cleaning agents and foodstuffs is
not permitted. Liquid temperature not to
exceed 35°C.
• Store the equipment in a dry place and
out of reach of children.
Caution! To avoid damage to the
equipment and any possible person
injury resulting from this:
• Do not work with damaged or incom-
plete equipment, or with equipment
that has been converted without the ap-
proval of the manufacturer. Before initial
operation, have a specialist check that
the required electrical protection meas-
ures are in place.
• Do not carry or fix the equipment by the
cable or pressure line.
• Protect the equipment from frost and
from running dry.
• Use only original accessories and do
not carry out conversion work on the
equipment.
• Please read the notes in the operating
instructions on the topic of “mainte-
nance and cleaning”. Any measures
above and beyond these, particularly
opening the equipment, are to be car-
ried out by an electrician. In the case
of repairs, always contact our service
centre.
Electrical safety:
Caution: to avoid accidents and inju-
ries from electric shocks:
• After erection, the mains plug must be
freely accessible when the equipment is
in operation.
• Before operating your new pump, have
a specialist check:
- The earthing, the protective multiple
earthing; the residual current circuit
breaking must be compliant with the
safety regulations of the energy supply
company and function without fault,
- The protection of the electrical plug
connections from the wet.
- If there is a risk of flooding, fix the
plug connections in an area that is
safe from flooding.
• Ensure that the mains voltage matches
the specifications on the rating plate.
• The electrical installation shall be ac-
cording to national wiring rules.
• Connect the equipment only to a sock-
et with a residual current protection
device (residual current circuit breaker)
with a rated current of not more than
30 mA; minimum fuse 10 amperes.
• Before each use, check the equipment,
cable and plug for damage. Defective
cables are not to be repaired, but rath-
er replaced by new ones. Have any
damage to your equipment repaired
by a specialist.
• If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer, a customer service agent
of the same or a similarly qualified per-
son in order to prevent hazards.
• Do not pull the plug from the socket by
the cable. Protect the cable from heat,
oil and sharp edges.
• Do not carry or fix the equipment by
the cable.
• Use only extension cables that are pro-
tected from spray water and designed
for outdoor use. Always fully unroll a
cable drum before use. Check the ca-
ble for damage.
• Before any work on the equipment,
during work breaks and in the case
of non-use, remove the plug from the
socket.
• The cross-section of mains connection
lines must be no smaller than rub-
ber hose lines with the designation
H07RN-F. The line must be 10 m long.