EVGA nForce 630i - Manual (Page 8)

Pow
24-p
8-pin
FD
Co
wer Con
This mothe
provide en
in ATX Pow
PWR1 is th
DIMM slo
connector
make sure
n ATX 12V P
PWR2 , the
the pins to
only fit in o
DD Connect
The mothe
drive (FDD
onnecting I
The IDE c
133/100/6
Connect th
motherboa
If you insta
drive as a s
the hard di
nnection
erboard requir
ough wattage
wer (PWR1)
he main powe
ts. Make sure
on the mothe
it is secure.
Power (PW
e 4-Pin ATX 1
the connecto
one way.
tor
erboard suppo
D).
DE Hard Di
connector sup
66 IDE hard d
he cable end w
ard.
all two hard di
slave device by
isk documenta
ns
res an ATX p
to power all t
r supply conn
that the powe
erboard. Firml
R2)
12V power con
or and press fir
orts a standard
isk Drives
ports Ultra AT
disk drives.
with a single co
isk drives, you
y setting its ju
ation for the ju
ower supply.
the componen
nector located
er supply cabl
ly plug the pow
nnection, is us
rmly until seat
d 360K, 720K
TA
onnector to th
u must configu
mper accordin
umper setting
Make sure yo
nts you will be
along the edg
e and pins are
wer supply ca
sed to provide
ted. The conn
K, 1.2M, 1.44m
he
ure the second
ngly. Refer to
gs.
our power sup
e installing.
ge of the board
e properly alig
ble into the co
e power to the
nection is notc
m, and a 2.88M
d
PWR1 connecto
Plug power cabl
from system pow
supply to PWR1
pply can
d next to the
gned with the
onnector and
e CPU. Align
ched and will
M floppy disk
or
e
wer