Crivit Z31953 - Manual (Page 5)

5 GB
never use the product when the ambient temperature
falls to below 15 ° C and rises above 40 ° C.
Otherwise damage to the product may result.
Note: Basically, only an adult should be responsible
for pumping the pool up. Make sure that you do
not pump too much air into the product. On no ac-
count should you use a compressor. Stop the process
when resistance increases during pumping and the
seams start to stretch. Otherwise the material might
tear. Only use manual pumps and / or pumps specifi-
cally designed for use with inflatable plastic products.
j Roll the product out first and then check for
holes, tears and other damage (see Fig. A).
Note: You will need a pump with conical ad-
apter (ø approx. 7.5 mm) for the air valve
6 to
inflate the product. Use a pump with conical
adapter with a diameter of approx. 17.5 mm
for the screw valve
2 .
j Turn the end cap 1 of the valve opening 2
anti-clockwise off the air valve in order to open it.
j Take the end cap 4 off the valve opening 5
in order to open the valve 6 .
j Pump the product up.
IMPORTANT! Keep in mind that air tempera-
ture and weather conditions can affect the air
pressure inside inflatable products. In cold
weather the product behaves as if it has less air
pressure in it because the air inside contracts.
Under these conditions you may have to add
air. In hot weather the air inside expands. Un-
der these conditions you may have to remove
air in order to avoid overfilling.
j Turn the end cap 1 of the valve opening 2
clockwise onto the air valve to close it.
j Place the end cap 4 onto the valve opening
5 in order to close the valve 6 .
Deflating the product
j Turn the stopper 3 anti-clockwise to open the
air valve.
j Pull the end cap 4 off the valve opening 5
in order to open the valve 6 .
j Press the sides of the air valve 6 together using
your thumb and index finger.
j Allow the air to escape completely.
j Slowly fold the product together (see Fig. A).
Note: Make sure that the product is completely
dry before folding it together.
Cleaning and Maintenance
J On no account should you use corrosive or
scouring detergents.
j Use a slightly damp, lint-free cloth to clean the
product.
Change the water of paddling pools frequently
(particularly in hot weather) or when noticeably
contaminated.
Repairing the product
Note: Minor damage can be repaired by the
owner using the supplied repair kit. Have any major
damage carried out at a specialist repair shop.
First let all the air escape from of the product.
Cut the patch 7 to suit the size of the hole.
Note: Ensure that the patch 7 is larger than
the hole and overlaps the edges of the hole.
Round off the sides of the patch 7 and pull
off the protective foil.
Place the patch 7 on the hole and press it
down firmly. If necessary, stand a heavy object
on the patch
7 .
Wait for 24 hours before you pump up the
product again.
Storage instruction
j Make sure that the product is completely dry
both inside and out when wishing to store it for
any length of time. Otherwise mildew and
mould may form.
j Store the product in a dark, dry place – out of
reach of children.
j The ideal storage temperature is 10 - 20 ° C.
103535_Planschbecken_Content_HU_CZ.indd 5 21.11.14 11:45