Electrolux EK 5731 - Manual (Page 23)

23
Conversion from Natural to LPG
Gas
IMPORTANT
The replacement/conversion of the gas hob
should only be undertaken by a CORGI
registered engineer.
It is important to note that this model is designed
for use with natural gas but can be converted for
use with butane or propane gas providing the
correct injectors are fitted. The gas rate is
adjusted to suit.
Method
• Ensure that the gas taps are in the 'OFF' position
• Isolate the hob from the electricity supply
• Remove all pan supports, burner caps, rings,
crowns and control knobs.
• With the aid of a 7mm box spanner the burner
injectors can then be unscrewed and replaced
by the appropriate LPG injectors (see Table:
page 19).
TO ADJUST THE GAS RATE
With the aid of a thin bladed screwdriver
completely tighten clockwise the by pass screw.
Upon completion stick the replacement rating
plate near the gas supply pipe.