Crivit TS-1808 - Manual (Page 10)

10
Turning the shock absorption system on/off
To disable the shock absorption system, fix the pole length as described
under “Adjusting the pole length”.
1. Turn the middle part of the product back fractionally against the
locking direction. You will then hear a clear click. This indicates that the
shock absorption system is disabled.
2. Turn the middle part back slightly in the locking direction in order to
activate the shock absorption system again.
Putting on the hand strap
Place the strap over the back of your hand and grip the handle.
Useful information about use
• Wear gloves in cold weather.
• On longer tours, you should ensure that you take enough to drink
(possibly a drinks belt or a drinks backpack).
• Wear clothing that is suitable for the weather.
Combination support for asphalt pad and
plate
The combination support can be used to store the asphalt pad.
Use the asphalt pad on rocky and hard surfaces, and use the hiking pole
plate on soft surfaces to prevent the product from sinking.
You can also remove the combination support. Pull the loop of the red
rubber ring from the duct on the support. The support can then be remo-
ved from the pole. To apply the combination support, put it back on the
pole, pull the rubber ring once around the pole and then place it back
in the duct on the combination support. If you are not using the asphalt
pads or the hiking pole plates for your current hiking trail, you can attach
them or insert them in the plate changer system mechanism.
Cleaning and maintenance
To clean the product, you can use a cloth soaked in lukewarm water
or soapy water. Never clean the product with solvent-based or strong
cleaning agents.
These may affect the plastic materials and markings and cause long-term
damage.
GB/MT