Crivit Football Goal Set - Manual (Page 3)

3 GB
Football Goal Set
Intended use
This product has been designed as a recreational
product for domestic and outdoor use. This product is
recommended to be used by children above 6 years.
This product is only suitable for playing football. This
product is designed as a piece of sports equipment
and is not intended for commercial use.
Please read all the information carefully before as-
sembling or using the product. Keep all the safety
advice and instructions in a safe place for future
reference.
Technical Data
Size (assembled): 240 cm x 170 cm x 84 cm
(L x H x D)
Weight: approx. 9350 g
Safety notes
Ignoring the safety notes can
lead to the risk of injury!
Select a piece of land that is as flat and firm as
possible as the position for the goal.
Ensure that there are no objects within a 2 m
radius of the product position.
Ensure that all the stakes are anchored firmly in
the ground, otherwise the product could tip over.
Secure the product also when it is not being used.
Do not climb on the product.
Before each use, make sure all the metal parts
are correctly attached and that the metal tubes
are not protruding.
This product should only be assembled by an
adult. Check for damage before every use.
Please check the condition of the ground where
the product stands. On loose ground, the stakes
could become loose and thus lead to a risk of
injury caused by the goal tipping over.
Remove the goal wall if it is not being used,
otherwise there is the risk it will become dam-
aged by gusts of wind.
Check at regular intervals that all the screws
are tight and retighten them regularly.
Avoid damage to property
During assembly, the protective coating of the metal
tubes could become damaged.
If necessary, grease the affected areas before
use, to prevent rust damage.
Assembly
Assembling the goal frame
Ensure that during assembly there are no objects
within a 3 m radius.
Connect the tubes, as shown in Figure A, in order
to fit the frame together.
Should the safety catches not pass straight into
the tubes, turn the tube or safety catches into
the correct position so that they lock together.
Warning: Take care when pushing the tubes
together that the safety catches lock into the
openings in the tube ends designed for them.
Note: In order to prevent injuries, the heads
of the screws must point in the direction of the
goal (see Fig. A).
Securing the goal net
Attach the net to the goal frame, as shown in
Figure B.
Position the net so that the red markings are in
the upper corners (see Fig. B1).
Secure the net to the back of the frame with the
aid of the hook and loop fastener (see Fig. B2).
Use the remaining hook and loop fasteners to
secure the net in the desired position on the
goal frame (see Fig. B3).
Then use the ropes to additionally secure the
net to the goal frame (see Fig. B4).