Seaside – Kichler 310131 User Manual

Page 5

Fig. 7

Fig. 5

Fig. 6

Set Screw

Canopy

Download

Motor Coupling

Washer

Set Screw

Fan Assembly

Lcok Pin

Hitch Pin

Cross Pin

Lock Pin

Hanger Ball

Screw

Downrod

Listed electrial

box

Washer

Mounting screw

Mounting bracket

Seaside

5. HANGING THE FAN

REMEMBER to turn off the power before you

begin.

Step 1. Pass the 120 volt supply wires from the ceiling

outlet box through the center of the ceiling mounting

bracket. (Fig. 5)

Step 4. Loosen the two set screws from the

coupling on top of the motor assembly. (Fig. 7)

Step 5. Carefully feed the electrical lead wires from

the fan up through the downrod. Thread the downrod

into the coupling until the hitch pin holes are aligned.

Next, replace the hitch pin and retaining clip.

Tighten both set screws. (Fig. 7)

To properly install your ceiling fan, follow the steps below.

Step 2. Attach the ceiling mounting bracket to the

outlet box using the screws and washers included

with the outlet box. (Fig. 5)

Step 3. Remove the hanger ball from the downrod

assembly by loosening the set screw, removing the

cross pin and sliding the ball off the rod. Remove

the hitch pin and retaining clip from the downrod

assembly. (Fig. 6)