beautypg.com

Installation, Network adapter, Figure 5-1 connect the hub and network device – Edimax Technology ER-5398S User Manual

Page 9: 100m, Category 3 eia/tia 568 utp cable

background image

5

5

Installation

1. Operating Environment

ER-5398S must be installed and operated within the limits of specified operating
temperature and humidity (see previous section under Specifications). Do not place
objects on top of the unit. Do not obstruct any vents at the sides of the unit. Do not
position the hub near any heating source such as heater, radiator, or direct exposure
to sun. Prevent entering of water and moisture into the unit. If necessary, use
dehumidifier to reduce humidity.

2. Connecting to network devices with UTP cable

Connect one end of the network cable to any of the RJ-45 ports on the front panel of
ER-5398S, and connect the other end of the network cable to the RJ-45 port of the
network device. The network cables must comply with EIA/TIA 568 specifications
and minimum Category 3 standard for 10Mbps data transmission. Maximum length
between the hub and workstation is 100 meters (300ft). Once the network cable is
connected on both ends and the attached network devices are powered on, the green
LNK/Rx (Link Status) LED should be lit.

3. Uplink to Another Hub with UTP cable

Use uplink port to connect to another hub as illustrated in Figure 1-2. Connect one
end of the network cable to the uplink port and connect the other end to any of the
regular port in the other hub (except the uplink port). Connecting cable must comply
with EIA/TIA 568 specifications and Category 3 standards to connect the hubs.
Once the network cable is connected and both hubs are powered on, the green
LNK/Rx (Link Status) LED should be lit. The maximum length of the uplink cable
shall not exceed 100 meters (300 feet).

NOTE: Do not use the uplink port and 16th port at the same time.

6

Figure 5-1 Connect the hub and network device

100m

10/100 FAST ETHERNET CARD
FCC ID :

RTL8139

Category 3

EIA/TIA 568

UTP Cable

Network
Adapter

LA

P R

O FE SSI

18

PORT/10 Mbps

ER-5398

10

BaseT

Ethernet

1

3

5

7

9

Link/Rx

Partition

Collision

Jabber

Power

2

4

6

8

10

12

14

16

11

13

15

1X

2X

3X

4X

5X

6X

7X

8X

13X

14X

15X 16MDI-X

9X

10X

11X 12X

16MDI

D I M A X