Electrolux EWF 6120 W - Manual (Page 28)

installation 55
3. Place the discharging hose in a
washbasin or sink with the aid of the
bent piece delivered separately. The
bent piece has to be entered into the
tube’s mouth in order to assure the
support. Aforesaid piece allows the
hose to be fixed to the wall by means
of an opening on the upper part and
that way the hose does not move and
its falling is avoided.
IMPORTANT:
The distance from the floor to the highest
part of the hose should be between 60
to 90 cm. (It is advised to be between 60
and 70 cm). The hose must not be bent
nor twisted to avoid clogging. Should a
prolongation of the discharging hose be
unavoidable this must never surpass 1.5
m and must be of the same diameter as
the original hose.
Make sure the hoses are not too tense
Levelling
Level the appliance by loosening or
tightening the feet. Once in the right
position fix the feet by pushing the nuts
against the base of the case. Accurate
levelling will prevent vibration, noise and
displacement of the appliance during
operation.
Some vibration is inevitable, especially if
placed on a wooden floor. Wooden
floors are particularly susceptible to
vibrations. If possible always place the
appliance on a solid floor.
Electrical connection
This machine is designed to operate on
a 230 V, single-phase, 50 Hz supply.
Check that your domestic electrical
installation can take the maximum load
required (2.1 kW), also taking into
account any other appliances in use.
The applicable rules for electrical
security require an adequate
earthing. The plug of the appliance
is provided with such a device.
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the above
safety precaution. Should the appliance
power supply cable need to be
replaced, this should be carried out by
our Service Centre.
Please ensure that when the appliance is
installed the power supply cable is easily
accessible.
126.2931.23…EWF6120W.qxd:- 10/03/09 15:43 Página 55