Electrolux EDB705 - Manual (Page 35)

PREPARING CABINET FOR
FITTING OVEN
Make sure the space between the cabinets is
the correct size for the appliance to be fitted
(Ref. Fig. 5 & 6).
The plinth board spanning the space into
which the appliance is to be installed should
be removed.
If the size between adjacent cabinets is
605-610mm, then the cabinets should be
modified so that the recommended dimension
of at least 600-605mm is maintained.
The adjacent cabinets must be stable and
firmly secured to the wall or floor. If
necessary, make arrangements to ensure the
work surface below which the oven will rest is
level.
Drill two pilot screw holes into the sides of the
adjacent cabinets, in the positions indicated
by Fig. 5.
Fit the appliance mounting brackets using the
two holes indicated in Fig.7 to the adjacent
cabinets ( Ref. Fig.5 & 6 )
35
INSTALLATION INSTRUCTIONS
Fig. 5
Fig. 7
Fig. 6