Emerson Radio CKD1100 - Manual (Page 12)

11
Listening To The Radio
1.) Press the ALARM OFF/POWER button on the top panel to turn the unit ‘On’.
The POWER LED indicator comes on.
2.) Press the RADIO/BAND button to select the Radio function. Either the
AM/PROG or the FM indicator will come on to confirm which band is selected.
Press the RADIO/BAND button again to repeatedly switch between the AM
and FM bands.
3.) Rotate the TUNING control on the right side panel to tune to the desired station.
4.) Rotate the VOLUME control on the left side panel to adjust the volume level.
5.) When you are finished listening press the ALARM OFF/POWER button to turn
the unit ‘Off’. The POWER LED indicator goes off.
Antenna Information
AM
The AM ferrite bar antenna is inside the cabinet. If AM reception is unsatisfactory
try turning the entire unit slightly until you find the direction that provides the best
reception for the desired station.
FM
Make sure the FM lead wire antenna is extended to it’s full length. You may have to
vary the direction of the wire antenna to find the position that provides the best
reception.
CKD1100_052107.p65 21/5/2007, 10:44 11