Assembling top cover and dust chute – Epson 22-681 User Manual
Page 11
11
ASSEMBLING TOP COVER AND
DUST CHUTE
1.
Fasten the top cover and dust chute (A) Fig. 16, to
the top of the planer, as shown, using the three
M6x16mm screws (B) supplied. IMPORTANT: The
dust chute opening (C) must point to the rear as
shown.
Fig. 16
Fig. 17
2.
Fasten the left corner of the cover to the top of the
planer using the remaining M6x16mm screw (D) Fig.
17, and cord clamp (E). NOTE: The motor cord (F)
must be inserted and positioned into the cord clamp
as shown.
D
E
F
B
B
C
A
Fig. 11
FRONT OF STAND
D
F
C
G
E
A
B
ASSEMBLING ACCESSORY 50-314
STAND
If you purchased the accessory 50-314 Stand for use
with your planer, assemble the stand as follows:
1. Assemble the stand, as shown in Fig. 11, using the
24 carriage bolts, 8 flat washers, 8 lockwashers
and 24 nuts supplied. NOTE: Eight carriage bolts
(A), flat washers, lockwashers and nuts are used to
mount the legs to the top shelf of the stand and
sixteen carriage bolts (B) and nuts are used to
mount the front, rear and side tie bars to the legs.
The two side tie bars (F), are 20-15/16" long and
the front and rear tie bars (D) are 23-7/16" long.
2. IMPORTANT: When lifting the planer to position it
on a stand or bench, refer to the following section:
“LIFTING THE MACHINE.”
3. The front end of the top shelf is indicated in Fig. 11.
Two slots (G), which are supplied on later models of
the 50-314 stand, indicate the rear end of the top
shelf. Place the machine on the top shelf with the
front (infeed) end of the machine toward the side of
the top shelf indicated as FRONT in Fig. 11. The
four holes in the base of the machine are to be
aligned with the four holes indicated on the top
shelf as (C) and (E) making sure that the left hand
side of the base will be over holes (E) and the right
hand side of the base will be over holes (C). The
offset between the top shelf of the stand and the
base of the planer will be on the left side. Mount
the machine to the top shelf using the four 1" long
hex head screws, flat washers, lock washers and
hex nuts supplied.