Electrolux 6919941 - Manual (Page 16)

16
Finishing the Connections
FINISHING THE WATER CONNECTION
1. Flush the water supply line to clear any foreign material before
connecting to the dishwasher.
2. Make sure that there are no sharp bends or kinks to restrict the water
flow.
3. Insert the water line into the 90° elbow. See Figure 15.
4. Slide the ferrule against the elbow and secure with the
compression nut.
5. Turn the water on to check for leaks.
6. Feed the dishwasher cable through the small hole in the junction box.
7. Replace the access cover.
FINISHING THE DRAIN CONNECTION
The dishwasher is supplied with a 72” long drain hose.
1. If a longer drain hose is required, add up to 48” of length for a total of 10 feet.
The hose must not restrict the flow from the drain of the dishwasher to the
house’s drain system. The type of hose used should be consistent with the
type and diameter installed on the dishwasher.
2. Secure the drain hose to the air gap, water tee or disposer with clamps.
3. Make sure the drain hose is not kinked.
NOTE
If you are using an existing water line, cut 1” off the end. Always use a new ferrule and
compression nut.
NOTE
Follow all local codes and ordinances.
NOTE
When connecting the drain line to the disposer, check to be sure
that the knockout plug has been removed. DISHWASHER WILL NOT
DRAIN IF THE PLUG IS LEFT IN PLACE.
1
2