Electrolux 6919941 - Manual (Page 11)

11
Making the Connections
2. Cut water access hole in cabinet as shown in Figure 3.
3. Route water supply line to installation area.
MAKING THE DRAIN CONNECTION
1. Follow local codes and ordinances.
2. Review Figure 4 and Figure 5, page 12 to see the different ways to connect
dishwasher to drain system. Choose the method that best suits your need.
3. If you connect to a sink drain, entry will need to be above the trap. A “Y”
branch tailpiece and connector kit, not included, will make this method easier
and included all needed fittings and instructions. See Figure 5, page 12.
NOTE
Incoming hot water temperature, set at the hot water heater, should be 120° F (49° C). Water
pressure should be between 20-120 psi.
CAUTION
To prevent siphoning, an air gap MUST BE USED when waste tee or disposer connection
is less than 18” above the floor to prevent siphoning. Failure to provide the proper drain
connection using an air gap or a 30” minimum high drain loop will result in improper
draining and may cause property damage or poor wash performance.
Figure 3
Through Cabinet
Entry Must be Above Trap
Sink at Left
Figure 4
Y-Branch
Tailpiece
Sink at Right
2” Drain Hose Hole