beautypg.com

Blades, Sharpening, Level 2 – Echo SHC-225S User Manual

Page 27: Shc-225/s maintenance

background image

SHC-225/S

MAINTENANCE

X7502257105

27

© 03/2013 ECHO Inc.

4. Install the gear housing assembly.

Flat edge of washers (D) must be against drive shaft.

Blades

Blades should only be removed and reinstalled by an Authorized ECHO Servicing Dealer, otherwise
premature wear or internal damage may occur.

Sharpening

Level 2.

Hedge Clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid
touching blades whenever possible, and always wear gloves to protect hands.

1. Move stop switch to stop position.
2. Disconnect spark plug wire.

3. Remove blade guard, if installed (see “Blade Guard

Remove/Install instructions”).

4. Slide blades to allow file clearance using slots (A) on bottom

of blade. Do not pry against cutting edges.

5. File each edge carefully. Follow the original shape of the

blade.

If a power grinder is used DO NOT allow blade to over heat.

6. Install blade guard, if necessary (see “Blade Guard

Remove/Install instructions”).

7. Lubricate blades (see “Lubrication”).
8. Connect spark plug wire.

Parts Required:

none

C

A

6 mm (.25 in.) radius

45

o