Echo SHC-225S - Manual (Page 26)

26 X7502257105
© 03/2013 ECHO Inc.
MAINTENANCE SHC-225/S
1. Clean dirt from the grease fitting (A).
2. Carefully pump grease into fitting (A). DO NOT force
grease. Too much pressure will force grease past seals and
cause damage. Apply 1-2 pumps of grease every 15-25
hours of operation.
3. Wipe excess grease from around grease fitting.
Drive Shaft Assembly
Level 1.
Hedge Clipper blades are very sharp. Touching them may
lead to severe personal injury. Avoid touching blades
whenever possible, and always wear gloves to protect hands.
1. Remove gear housing locating screw (A) and loosen
clamping screw (B). Remove the gear housing assembly
from the drive shaft housing..
2. Pull the drive shaft (C) from the housing, wipe clean and
re-coat with a thin coating [1/2 oz. (15 ml)] of grease.
3. Slide the drive shaft back in the drive housing being careful
not to get dirt on the flex shaft.
Parts Required: POWER BLENDX TM 14 oz. or Lithium Base
Grease.
A
A
B D
A
B
D