beautypg.com

Starting cold engine, Shc-225/s operation – Echo SHC-225S User Manual

Page 17

background image

SHC-225/S

OPERATION

X7502257105

17

© 03/2013 ECHO Inc.

Starting Cold Engine

Hedge Clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid
touching blades whenever possible, and always wear gloves to protect hands.

Note: The blade cover is used for transportation and storage. Remove blade cover before using the unit.

The attachment will operate immediately when the engine starts, and could result in possible
serious injury.  Keep movable parts of the attachment away from objects that could become
entangled or thrown, and surfaces that could cause loss of control.

1. Stop Switch

Move stop switch (A) away from the STOP position.

2. Choke

Move choke (B) to Cold Start () (closed) position.

3. Purge Bulb

Pump purge bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5
times.

4. Recoil Starter

Lay the unit on a flat area and keep movable attachment parts
clear of all obstacles. Firmly grasp throttle handle and throttle
trigger lockout with left hand and fully depress throttle trigger
to wide open position. Rapidly pull recoil starter handle/rope
(D) until engine fires (or maximum five [5] pulls).

5. Choke

After engine fires (or 5 pulls), move choke (B) to the Run
(

) (open) position. Firmly grasp throttle handle and throttle

trigger lockout with left hand and fully depress throttle trigger
to wide open position. Pull starter handle/rope until engine
starts and runs. Release throttle trigger and allow unit to warm up at idle for several minutes.

Note: If engine does not start with choke in “Run” position after 5 pulls, repeat instructions 2 - 5.

A

B

C

D