Epson 50c - Manual (Page 2)

EPSON PowerLite 50c/70c
If you see a blank screen or the No Signal message
after turning on your laptop, check the following:
Make sure the power light is green and
not flashing and the lens cap is off.
Try turning off the laptop and restarting it.
If you’ve connected more than one computer and/or video source,
you may need to press the Source button on top of the projector.
(Allow a few seconds for the projector to sync up after pressing it.)
Adjust the image
1 Remove the lens cap and rotate the focus ring
to sharpen the image.
If You See a Blank Screen
Press the function key that lets you display on an external monitor.
It may have an icon such as , or it may be labelled CRT/LCD.
You may have to hold down the Fn (function) key while pressing it.
(Allow a few seconds for the projector to sync up after pressing
the key.) Check your laptop’s manual or online help for details.
On most systems, the or CRT/LCD key let you toggle between
the LCD screen and the projector, or display on both at the same
time.
You might need to use the Display utility in the Control Panel
to enable both the LCD screen and external monitor port.
If you’re using a Windows laptop:
If you’re using a Macintosh ® :
CPD-11579
EPSON is a registered trademark of SEIKO EPSON CORPORATION. PowerLite is a registered trademark of Epson America, Inc.
Copyright © 2001 by Epson America, Inc. 1/01
2 Raise the image as needed. To do this, pull up the blue foot
release levers and lift the front of the projector. Once the
image is positioned where you want it, release the levers
to lock the feet in position.
3 If your image looks like or , you’ve placed the projector
at an angle to the screen. Move it directly in front of the
center of the screen, facing the screen squarely.
4 If your image looks like or , press the + or – side of
the Keystone button to correct the shape of the image.
EPSON PowerLite 50c/70c
Note: If you see a blank screen after focusing,
see the box below.
1. From the Apple menu, select Control Panels, then click Monitors
and Sound.
2. Click the Arrange icon.
3. Drag one monitor icon on top of the other. This lets you display
on the projector screen as well as the LCD screen.
If this option isn’t available, you may need to select one of the
Simulscan resolution settings:
1. Perform step 1 above, if necessary.
2. Click the Monitor icon.
3. Select a Simulscan resolution as shown. (Allow a few seconds for
the projector to sync up after making the selection.)
focus ring
No signal
drag one monitor icon
on top of the other
click here
select a Simulscan
resolution
click here
No signal