beautypg.com

Caution, Model 1000 suitable for use in mobile homes, Made in canada – Enviro ENVIROFIRE 1600 User Manual

Page 16

background image

DO NOT REMOVE THIS LABEL

WH-

LISTED SOLID FUEL SPACE HEATER SERIAL NO.

MODEL:

1000

1600

2100 1600 INS

MODEL 1000 SUITABLE FOR USE IN MOBILE HOMES.

CERTIFIED FOR CANADA AND THE U.S.A. REPORT NO. J99011443-231
TESTED TO CSA B366.2/ULC-S627, ULC-S628-M93, UL-1482-1994

REPORT NO. 6385

INSTALL AND USE ONLY IN ACCORDANCE WITH THE MANUFACTURERS INSTALLATION AND OPERATING INSTRUCTIONS. CONTACT LOCAL

BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION IN YOUR AREA. USE 6 IN. / 150 MM DIAMETER
MINIMUM 24 MSG BLACK OR 25 MSG BLUED STEEL CONNECTOR LISTED FACTORY-BUILT CHIMNEY SUITABLE FOR USE WITH SOLID FUELS
OR MASONRY CHIMNEY. SEE LOCAL BUILDING CODE AND MANUFACTURER’S INSTRUCTIONS FOR PRECAUTIONS REQUIRED FOR PASSING
A CHIMNEY THROUGH A COMBUSTIBLE WALL OR CEILING. DO NOT PASS CHIMNEY CONNECTOR THROUGH A COMBUSTIBLE WALL OR
CEILING. MINIMUM CLEARANCES FROM HORIZONTAL CONNECTOR AND CEILING (18 IN./ 455 MM) DO NOT CONNECT THIS UNIT TO A
CHIMNEY FLUE SERVICING ANOTHER APPLIANCE U.S.A. ONLY.


MINIMUM CLEARANCES TO COMBUSTIBLE MATERIALS

RESIDENTIAL INSTALLATIONS USING SINGLE WALL CONNECTOR. WITH ANY ULC-S629 LISTED CHIMNEY IN CANADA , AND

ANY UL 103 HT LISTED CHIMNEY SYSTEMS IN THE U.S.A.

MODEL :1000

MODEL: 1600

MODEL: 2100

SIDE WALL TO UNIT A
BACK WALL TO UNIT B
CORNER TO UNIT C
SIDE WALL TO CONNECTOR D
BACK WALL TO CONNECTOR E
CORNER TO CONNECTOR F

19 IN. / 485 MM
10 IN. / 255 MM

6 IN. / 150 MM

28 IN. / 710 MM
13 IN. / 330 MM
16 IN. / 405 MM

20 IN. / 510 MM
12 IN. / 305 MM

6 IN. / 150 MM

29 IN. / 735 MM

16.5 IN. / 420 MM

16.5 IN. / /420 MM

22 IN. / 560 MM
12 IN. / 305 MM

8 IN. / 205 MM

31 IN. / 790 MM

16.5 IN. / 420 MM

19 IN. / 485 MM


COMPONENTS REQUIRED FOR MOBILE HOME INSTALLATIONS: MODELS 1000 AND 1600

IN CANADA: ANY ULC-629 LISTED CHIMNEY SYSTEM WITH THE ACCOMPANYING DOUBLE WALL VENT CONNECTOR
IN U.S.A.: ANY HT-103 LISTED CHIMNEY SYSTEM WITH THE ACCOMPANYING DOUBLE WALL VENT CONNECTOR

SPECIFIED CLEARANCES APPLY AND UNITS MAY BE INSTALLED IN CONVENTIONAL HOMES IF SPECIFIED CONNECTORS ARE USED.

MODEL 1000

MODEL 1600

SIDE WALL TO UNIT A
BACK WALL TO UNIT B
CORNER TO UNIT C
SIDE WALL TO CONNECTOR D
BACK WALL TO CONNECTOR E
CORNER TO CONNECTOR F

14 IN./ 355 MM
6 IN. / 150 MM

2 IN. / 50 MM

23 IN. / 585 MM

9 IN. / 230 MM

11.5 IN. / 290 MM

11 IN. / 280 MM

4 IN. / 101 MM
6 IN. / 153 MM

20 IN. / 508 MM

8.25 IN. / 210 MM
15.5 IN. / 394 MM

MODEL 1000 MAY BE INSTALLED IN AN ALCOVE: ALCOVE DEPTH, 4 FT. /1.22 M, HEIGHT 7 FT. 2.13 M
MODEL 1600 MAY BE INSTALLED IN AN ALCOVE: ALCOVE DEPTH 30” (76 CM) HEIGHT 70”(178 CM) WIDTH 48” (122 CM)
ROOM HEATER, SOLID FUEL TYPE, SUITABLE FOR MOBILE HOMES

If a stove is installed on a combustible floor, it must have a
pedestal attached and be on a NON COMBUSTIBLE hearth pad
extending at least 8” (200 mm) to each side, and 18” (455 mm)
to the front

MODEL 1600 INS MAY BE INSTALLED AS AN INSERT IN A MASONRY

FIREPLACE.


MINIMUM CLEARANCES TO COMBUSTIBLE MATERIALS (MEASURE TO UNIT)

MODEL 1600 INS

ADJACENT SIDE WALL A
MANTLE B
TOP FACING C
SIDE FACING D

17 IN. / 430 MM

28 IN. / 710 MM

28 IN. / 710 MM

1 IN. / 25 MM


HEARTH EXTENSION MUST BE RAISED (F) 8 IN. / 205 MM ABOVE A SURROUNDING COMBUSTIBLE FLOOR.

COMBUSTIBLE FLOOR MUST BE PROTECTED BY A NON-COMBUSTIBLE MATERIAL EXTENDING (E) 18 IN.
455 MM TO THE FRONT OF THE UNIT AND (F) 8 IN. / 205 MM TO THE SIDES

OPERATE ONLY WITH THE DOOR AND ASH PAN CLOSED. ONLY OPEN DOOR TO FEED FIRE. FOR USE WITH SOLID WOOD FUELS ONLY. DO NOT

USE GRATE OR ELEVATE-FIRE BUILD WOOD FIRE DIRECTLY ON HEARTH. DO NOT OVERFIRE, DO NOT OBSTRUCT COMBUSTION AIR
OPENINGS.. IF HEATER OR CHIMNEY CONNECTOR GLOWS, YOU ARE OVERFIRING. INSPECT AND CLEAN CHIMNEY FREQUENTLY-UNDER
CERTAIN CONDITIONS OF USE, CREOSOTE BUILDUP MAY OCCUR RAPIDLY. KEEP FURNISHING AND OTHER COMBUSTIBLES WELL AWAY
FROM HEATER. REPLACE GLASS ONLY WITH CERAMIC GLASS. OPTIONAL COMPONENTS: FAN, ELECTRICAL RATING 115V, 60 Hz 1 AMP.
ROUTE CORD AWAY FROM HEATER.

MANUFACTURED BY:

SHERWOOD INDUSTRIES LTD.

6782 OLDFIELD RD.
VICTORIA B.C V8M-2A3

MADE IN CANADA

CAUTION

HOT WHILE IN OPERATION. DO NOT TOUCH. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY.

CONTACT MAY CAUSE SKIN BURN. READ NAMEPLATE AND INSTRUCTIONS.

16

This manual is related to the following products: