Ei Electronics Ei151TLR - Manual (Page 2)

Shannon Free Zone, Shannon, Co. Clare, Ireland.
Ph. +353 61 471277 Fx. +353 61 471053
Email. [email protected]
Web: www.eielectronics.com
E & OE As our policy is one of continuous product development, we reserve the right to alter product details without prior not ice . Ei151TLR DataSht RevB
Model Ei151TLR Ionisation
Installation & Placement
Wiring for Interconnected Alarms
Be very careful about correctly wiring the alarms as mixing Live and Neutral
will blow/damage interconnected alarms.
Alarms should be placed in accordance with the general guidelines shown in
the diagram above. These recommendations are based on the problem of
areas of “dead air” close to corners of rooms and apexes of ceilings, which
could result in the prevention of smoke reaching the smoke detector
Please consult instruction booklet for specific installation details
Important Precaution:
Do not install the actual smoke/heat
alarm itself in new or renovated
buildings until all work is completed
(including floor coverings) and the
building has been fully cleaned. The
wiring can be installed when
appropriate. (Excessive dust and debris
from building work can contaminate the
smoke chamber and cause problems,
and it will also invalidate the guarantee).
If it must be installed, cover it
completely, particularly around the
edges, with a dust cover (eg. a plastic
bag), until all cleaning is finished..
Connect wires to the unit as in wiring
diagram. All wiring must comply with
local codes.
Technical Specification
Sensor Ionisation
Sensitivity:
Complies with BS 5446 Part 1:
2000
Source:
Americium 241
Button Test:
Simulates the effect of smoke and
checks electronics and horn.
Supply Voltage:
230V AC
Battery back-up:
Rechargeable lithium cells
Power-On Indicator:
Continuous green LED
Alarm:
Electronic Piezoelectric horn
in unit
Alarm Sound Output:
85dB (minimum) at 3m
Alarm Status:
Red LED flashes every second on
unit sensing fire
Temperature Range: 0° to 40°C
Humidity Range:
15% to 95% Relative Humidity
Remote control:
Ei152, Ei159 or MCP400
Interconnect:
Up to 12 interconnected
Ei150/151TL/151TLR/154TL/155/1
56TLH/156TLR smoke or heat
alarms, along with an EI158 relay
base
Fixing:
Screw fixings supplied
Plastic material:
UL94VO flame retardant
Dimensions:
140mm x 120mm x 46mm
Weight:
227g
Warranty:
5 year (limited) warranty
Approvals:
Kitemarked to BS EN 14604:2005,
CE Approved
Specifications are subject to change