Empty the grass box, Hours of operation, Technical data – Powerplus POWXG6107T LAWNMOWER 1600W 420MM +GRASS TRIMMER EN User Manual
Page 10: Noise, Maintenance and storage, Powxg6107, 8 technical data, 9noise, 10 maintenance and storage
POWXG6107
EN
Copyright © 2014 VARO
P a g e
| 10
www.varo.com
7.4
Empty the grass box
To prevent the ejector opening / blade becoming clogged and unnecessary overloading of the
motor , empty the grass box once it is full.
7.5
Hours of operation
Observe your national and regional regulations for the protection against noise which specify
hours during which a lawn mower may be operated.
8 TECHNICAL DATA
Rated Voltage
220-240V
Rated frequency
50Hz
Rated Power
1600W
Rotation speed
3000min
-1
Cutting width
420mm
Weight
15kg
Collect box/ bag
45L
Cutting height
20-70mm
Material housing
Plastic
Grass box material
Hard plastic
Number of height positions
6
Adjustable handle height
Yes
Carbon brush motor
Yes
Diameter front wheel
160mm
Diameter rear wheel
220mm
9
NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
82dB(A)
Acoustic power level LwA
96 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration)
1.7m/s²
K = 1,5 m/s²
10 MAINTENANCE AND STORAGE
Make sure all fasteners (screws, nuts, ect.) are always fully tightened so that you can work
safely with the mower.
Check the grass box for wear and tear at regular intervals.
Replace any worn or damaged parts.
Regular care of your lawnmower will not only increase its service life but will also facilitate
the meticulous and easy mowing of your lawn. Clean the lawnmower with brushes or
cloths. Do not use any solvents or water to remove dirt. Always switch off the motor and
pull out the power plug before carrying out any maintenance and cleaning work.
The part most susceptible to wear and tear in the machine is the blade. Check the
condition of the blade and its fastener at regular intervals. If the blade is worn, it must be
replaced or sharpened. If the mower vibrates excessively, this means that the blade is
either not balanced correctly or has been bent out of shape by knocks, in which case it
must be repaired or replaced.