Powerplus POWX320 VACUUM CLEANER WET/DRY 800W EN - Manual (Page 6)

POWX320
EN
Copyright © 2013 VARO P a g e | 6 www.varo.com
7 ASSEMBLY
Mounting the swivel castors
 Remove the motor housing (2).
 Turn the tub (5) upside down and insert the swivel castors (7) in the openings creating an
imaginary square while placing them.
 Turn the tub upright again.
 Re-fit the motor housing.
Mounting the hose
 Insert the hose (8) in the connection (6) and press it on firmly.
Fitting and removing the motor housing
 The motor housing has been locked to the tub with clamps.
 To remove the motor housing (2), first remove the clamps (4) and then lift it from the tub (5).
 To re-fit the motor housing, place it on the tub and tighten the clamps.
Fitting the dust filter( FIG B)
A dust bag is suitable for collecting small waste material and dust.
 Remove the motor housing (2).
 Place mesh around filter.
 Suspend the dust filter in the tub.
 Re-fit the motor housing.
Mounting the tube to the hose
 Connect hose and tube to handle with air valve.
 Place the required nozzle on the tail end of the tube.
8 OPERATION
Make sure the power cord has been fully unwound before you switch on the machine. The air
leaving the grids must not be hindered.
When using the machine in combination with an electrical tool, switch on the machine first and
then the electrical tool.
Switching on and off

To switch the machine on, set the on/off switch (1) to “I”.
 To switch the machine off, set the on/off switch (1) to "0".
Mounting dust bag
The vacuum cleaner can be used with/or without dust bag for dry usage.
Vacuuming up waste material
 Check whether the dust filter has been fitted.
 Mount the tube (10) to the hose (8).
Vacuuming up dust released from an electrical tool
 Check whether the dust filter has been fitted.
 Connect the hose (8) directly to the dust extraction outlet of the electrical tool.
Vacuuming up liquids
 Check whether the dust filter and dust bag have been removed.
 Make sure the inside of the tub (5) is clean and free from dust.
 Mount the tube (10) to the hose (8).