Powerplus POWX311 VACUUM CLEANER WET/DRY 1000W EN - Manual (Page 5)

POWX311
EN
Copyright © 2008 VARO P a g e | 5 www.varo.com
6.2 Fitting the dust filter.
A dust back is suitable for collecting small waste material and dust.
§ Remove the motor housing (11).
§ Take out the filter by pulling it up.
§ Place the dry filter back into the appliance. Make sure the filter is properly installed.
§ Re-fit the motor housing.
6.3 Assembly of the appliance
§ Insert the flexible hose (1) into the vacuum hose connection (12). Turn the swivel connector
of the flexible hose to the right to lock into position. To remove the flexible hose, turn the
swivel connector to the left.
§ Connect the elbow connector (3) with the other end of the flexible hose (1).
§ Insert the narrow end of the telescopic tube (4) into the elbow connector (3). If required, the
second extension tube can now be added.
§ Fix the floor brush (15), liquid adapter (16), upholstery nozzle (18), crevice tool (19) or the
dusting brush (20) on the telescopic tube (4).
§ Carefully unravel the necessary length of power cord before you connect it to the mains
supply. During use, always unravel the power cord to at least two-thirds of its length to
avoid a tripping hazard.
ATTENTION: Never pull or carry the appliance by the power cord.
7 OPERATION
7.1 Switching the device ON/OFF:
§ Connect the power plug to a suitable outlet (220-240 volt).
§ Adjust the desired attachment.
§ Press the ON/OFF (7) button to turn on the appliance.
§ During operation, you can use the suction power slide (2) to adjust the suction power. The
more you open the slide (2), the lower the suction power.
§ In order to turn off the appliance, use the ON/OFF (7) button.
ATTENTION: Danger of injury. Unrevealled power cord may cause tripping
hazard.
Please pull out the power source or the plug after each use.
7.2 Dry Vacuum Cleaning
§ Check whether the dust filter has been fitted,
§ Mount the tube (4) to the hose (1).
ATTENTION: Check that accessories are not blocked or damaged and are in
good working order. Damaged parts must be replaced. Blocked hoses or
tubes will impair performance and may damage the appliance.
7.3 Wet Vacuum Cleaning:
§ Make sure that the power plug is unplugged.
§ Remove the motor unit (11) by undoing the two hinges and lifting off the head. Insert the
filter.
§ Make sure the dust/water container (13) is clean and free from dust and dirt.
§ Attach the appropriate attachment.