Powerplus POWX242 TILE CUTTER 1100W 240MM EN - Manual (Page 6)

POWX242
EN
Copyright © 2014 VARO p a g e | 6 www.varo.com
 Do not perform any design, assembly or Construction activities on the table while the
machine is switched on.
 Unplug the machine and clean the table before leaving the work area.
 Wear protective glasses, dust mask, ear defenders, work gloves and protective-sliding
shoes.
 Keep the table flat and do not scratch or press the table.
 Do not put hands anywhere near the blade whilst it is rotating.
 Do not attempt to free a jammed blade without first switching off or removing the plug from
the mains power supply.
 Do not cut small workpiece and also do not use for a purpose not intended.
 Keep water full in the tank when you operate the cutter.
 Do not use any solvents for instead water in this tool.
6.1 Power supply
 This tile saw must be connected to an earthed 230V - 50Hz power source.
 This power source must be secured by a 16A fuse.
 Your machine is supplied with a 30mA residual current device to protect the user against
electric shock.
 It can only protect you when the power mains to which the tool is plugged is properly
grounded.
 Have the proper outlet installed by a qualified electrician.
 Check with a qualified electrician or service personnel if the grounding instructions are not
completely understood, or if in doubt as to whether the tool is properly grounded.
6.2 Using an extension lead
 The use of any extension lead will cause some loss of power.
 To keep this to a minimum and to prevent overheating and motor burn-out, ask advice
from a qualified electrician to determine the minimum wire size of the extension lead.
 The extension lead should be equipped with an earthed type plug that fits the power
supply outlet at one end, and with an earthed type socket that fits the plug of the machine
at the other end.
7 ADDITIONAL SAFETY INSTRUCTIONS FOR LASERS
 Warning! The laser beam potentially causes severe eye damage. Never look or stare
directly into the laser beam.
 During use, do not point the laser beam at people, directly or indirectly through reflecting
surfaces.
 This laser complies with class 2 according to EN 60825-1:2001. The unit includes no
servicing components. Do not open the housing for any reason. If the unit is damaged,
have the damage repaired by an authorized repair agent.
Attention
Laser beam
Do not stare into the beam
laser class 2
Laser class : class 2
Laser wave length : 650 nm
Laser output : ≤1 mW
The laser on this machine is equiped with 2 AAA batteries.