Powerplus POWX190 SCROLL SAW 85W EN - Manual (Page 4)

POWX190
EN
Copyright © 2013 VARO P a g e | 4 www.varo.com
 Store idle power tools out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
 Maintain power tools. Check for misalignment or sticking of moving parts, breakage of
parts and any other condition that may affect the power tool’s operation. If damaged, have
the power tool repaired before use. Many accidents are caused by poorly maintained
power tools.
 Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to stick and are easier to control.
 Use the power tool, accessories and tool bits etc., in accordance with these instructions
and in the manner intended for the particular type of power tool, taking into account the
working conditions and the work to be performed. Use of the power tool for operations
different from intended could lead to a hazardous situation.
4.5 Service
 Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
5 ADDITIONAL SAFETY INSTRUCTIONS FOR SCROLL SAWS
 Wear safety glasses and a protective mask.
 Use the scroll saw solely indoors
 Make sure the saw teeth are pointing downward before using the appliance.
 If teeth are missing or damaged, replace the saw blade immediately.
 Use the scroll saw on a flat and stable surface.
 Never apply lateral pressure to the blade. It could break.
 Check wooden workpieces for the presence of nails etc. and remove them.
 Do not put your hands on the cutting surface of the saw.
 Never leave the saw unattended.
 Bits of wood, etc, lying near the saw should never be removed while the appliance is
running. Shut off the machine before you remove such items.
6 ASSEMBLY
6.1 Mounting the protective hood (fig. 1)
 Before starting the appliance, install the protective hood (5).
 Insert the screw from the left; then install the mounting and washer from the right. To
make things simpler the washer (A) need not be installed.
 Tighten the clamps.
6.2 Assembly of transverse guide (fig. 2)
 The transverse guide (3) is for mitre sawing; the transverse guide (3) can also be used at
the same time as a support for the material as you guide it through the saw.
7 OPERATION
7.1 Inclination of the table. (fig. 3)
The saw bench can be tilted 45 degrees. This is done as follows:
 Loosen the lock nut under the bench
 Tilt the bench by hand until the desired angle is reached.
 The angle can be read from a calibrated scale on the appliance.
 Tighten the lock nut.