Powerplus POWX112 HAMMER DRILL 1050W EN - Manual (Page 7)

POWX112
EN
Copyright © 2013 VARO P a g e | 7 www.varo.com
8 OPERATION
Important! When hammer drilling you will require a low pressure. Too much
pressure will place unnecessary load on the motor. Check the drill bits
regularly. Resharpen or replace blunt drill bits.
8.1 Switch on/off and selecting rotation speed.
Plug the cord set into power socket.
To start the tool squeeze the on/off switch (10).
To stop the tool , release the on/off switch.
If you press the lock-on button (8) while the
on/off switch is depressed, the on/off switch is
kept in the operating position.
To release the on/off switch (10) again, press it
briefly to and turn the tool off.
The harder you squeeze the on/off switch (10)
the faster the tool will operate.
Use lower speeds for starting.
Preselecting a max speed :
By turning the speed setting ring (9), you can
preset a max speed. When the on/off switch is
fully pressed, the speed is limited to this preset
Max.
8.2 Forward/reverse lever
The forward/reverse lever (7) is to determine the direction of rotation of the tool.
To select forward rotation, release the on/off switch and push the forward reverse lever to right
(R) side of the tool. To select reverse, push the lever to left (L) side of the tool.
When changing the position of the lever, be sure the on/off switch is released and the motor is
stationary.
8.3 Replacing the carbon brush
Check the carbon brushes regularly, there are two light on the handle, when the red LED is
lighted ,you should replace the carbon brushes.
Always replace carbon brushes in pairs.
9 TECHNICAL DATA
Model POWX112
Voltage 230-240V~ 50Hz
Power Input 1050 watt
No Load Speed 0-1100 min-1
Impact Rates 0-5200 min-1
Shank Style SDS
Max. Drilling Capacity Concrete 26mm
Steel 13 mm
Wood 40mm
Net Weight 4,9 kg
Insulation Class
/ II