Powerplus POWX112 HAMMER DRILL 1050W EN - Manual (Page 5)

POWX112
EN
Copyright © 2013 VARO P a g e | 5 www.varo.com
 Protect the power cable from damage. Oil and acid can damage the cable.
 Never overload the machine. Secure all work pieces sufficiently.
 Important! It is imperative to follow all national safety regulations concerning installation.
Operation and maintenance.
 Chisel bits and drill bits may be flung out of the machine accidentally and cause serious
injury.
 Before starting to work, always check that the chisel or drill bit is properly locked in the
chuck.
 Examine the chuck regularly for signs of wear or damage.
 Never start up a hammer tool until it pressed against a work piece (wall, ceiling, etc).
 When you are finished, unplug the hammer drill from the electric supply and remove the
chisel or drill bit from the machine.
 Always disconnect the hammer drill from the electric supply before you change a chisel or
drill bit.
 Protect your eyes and other workers from flying particles and splinters. Wear a helmet! Set
up partition walls!
 Wear work gloves to protect fingers from bruising and grazing.
 Vibrations can injure the hand-arm system. Keep exposure to vibrations as short as
possible.
 Always lead the mains cable away backwards from the device.
 Store the device where it is inaccessible to children.
 When carrying out work, always hold the device with both hands and ensure that you have
a stable standing position.
7 BEFORE STARTING WORK
 Examine the place where the device is to be used for hidden electrical cables, gas and
water pipes using a pipe finding device.
 Before connecting to the mains, ensure care that the mains voltage corresponds to the
details on the rating plate.
7.1 Fitting and changing tools (Fig.2)
The device is equipped with a SDS- plus attachment system.
 Clean tools and grease with a thin layer of machine
grease before fitting.
 Pull back fastening sleeve (A) and hold.
 Push and rotate the dust-free tool into the tool holder as
far as it will go. The tool will lock automatically.
 Check that it has locked by pulling the tool.
Removing SDS-plus tool
 Pull back fastening sleeve (A), hold and remove tool.
7.2 Mounting/Dismount the auxiliary 13mm chuck for drilling in steel, wood and
plastic
Mount:
 Clean the adapter shank and put a bit of grease
on it.
 Push the auxiliary chuck into the SDS chuck.
 Turn slowly to the right.
Dismount:
 Pull back fastening sleeve (A), hold and remove
tool.