Powerplus POWX091 ROUTER 1200W+12 ROUTER BITS EN - Manual (Page 6)

POWX091 EN
Copyright © 2014 VARO P a g e | 6 www.varo.com
Attention: Plastic parts are best routed at low speeds!
Do not store the tool until it has completely stopped.
Do not store in dusty places. Dust can get into the machine everywhere and cause the
mechanical parts to malfunction.
9 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
9.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10 TECHNICAL DATA
Voltage 230-240V
Mains frequency 50 Hz
Power 1200W
No load speed 11 500-30 000 min
-1
Cutting depth 35 mm
Spindle diameter cutter 8 mm
Weight 3.3 kg
Protection Class II
Double insulated
11 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
86 dB(A)
Acoustic power level LwA 97 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration) 6,23 m/s² K = 1,5 m/s²
12 SERVICE DEPARTMENT
 Damaged switches must be replaced by our after-sales service department.
 If the connecting cable (or mains plug) is damaged, it must be replaced by a special
connecting cable which is available from our service department. Replacement of the
connecting cable should only be carried out by our service department (see last page) or
by a qualified specialist (qualified electrician).