Powerplus POWX091 ROUTER 1200W+12 ROUTER BITS EN - Manual (Page 4)

POWX091 EN
Copyright © 2014 VARO P a g e | 4 www.varo.com
 Do not reach out too far. Keep your feet firmly on the ground at all times. This will enable
you retain control over the power tool in unexpected situations.
 Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and
gloves away from the power tool. Loose clothes, jewellery or long hair can become
entangled in the moving parts.
 If there are devices for connecting dust extraction and collection facilities, please ensure
that they are attached and used correctly. Using such devices can reduce dust-related
hazards.
5.4 Power tool use and care
 Do not expect the power tool to do more than it can. Use the correct power tool for what
you want to do. A power tool will achieve better results and be safer if used in the context
for which it was designed.
 Do not use the power tool if the switch cannot turn it on and off. A power tool with a broken
switch is dangerous and must be repaired.
 Disconnect the plug from the power source before making adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
 Store power tools, when not in use, out of the reach of children and do not allow people
who are not familiar with the power tool or these instructions to operate it. Power tools are
potentially dangerous in the hands of untrained users.
 Maintenance. Check for misalignment or jammed moving parts, breakages or any other
feature that might affect the operation of the power tool. If it is damaged, the power tool
must be repaired. Many accidents are caused by using poorly maintained power tools.
 Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to jam and are easier to control.
 Use the power tool, accessories and cutting tools, etc., in accordance with these
instructions and in the manner intended for the particular type of power tool, taking into
account the working conditions and the work which needs to be done. Using a power tool
in ways for which it was not intended can lead to potentially hazardous situations.
5.5 Service
 Your power tool should be serviced by a qualified specialist using only standard spare
parts. This will ensure that it meets the required safety standards.
6 SPECIFIC SAFETY WARNINGS
 Always use cutters with the correct spindle diameter.
 Always use cutters suitable for the speed of the machine.
7 ASSEMBLY
7.1 Inserting and removing the router bit (Fig. 6)
 Press the spindle lock (7) in and turn the collet nut (6) until it enters the slot of the spindle
lock. Keep holding the spindle lock pressed in as you complete this procedure.
 Open the collet nut with the spanner.
 Place the shaft of the router bit in the opening of the bit holder.
 Tighten the collet nut until the router bit is firmly in place.
 Loosen the collet nut again when you want to replace the bit.
If you wish to replace the bit during your work wait until the tool has come
to a complete stop and the router bit has cooled down.