Powerplus POWX0617 ANGLE GRINDER 2500W 230MM EN - Manual (Page 9)

POWX0617
EN
Copyright © 2013 VARO p a g e | 9 www.varo.com
8 OPERATON MODES
8.1 Grinding
Hold the handle (4) and auxiliary handle (7)
firmly and switch on. Avoid blocking the
ventilation slots with your hand, as this may
cause the grinder to overheat. Let the disc reach
full speed. Apply the grinder to the item.
Maximum effect is achieved when the grinder is
held at an angle of 15-30°in relation to the item.
Move the grinder gently along the item. Give the
grinder time to work. It is rarely necessary to
press the disc hard against the surface to be worked. Sparks can occur in the motor
compartment during use. This is normal and does not mean the grinder is defective. Switch off
the grinder after use.
9 FLANGE ARRANGEMENTS WHEN USING GRINDING WHEELS
9.1 Flange arrangements when using a depressed centre or straight grinding wheel
1 Clamping flange
2 Flange nut
10 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
10.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10.2 Lubrication
The machine does not require any specific lubrication.