beautypg.com

Operating instructions – Powerplus POW754 PAINT SPRAY GUN 600W EN User Manual

Page 6

background image

POW754

EN

Copyright © 2014 VARO

P a g e

| 6

www.varo.com

To remove the paint cup, twist in a clockwise
direction. Fill and dilute if required.

Connect the compressor unit to the mains supply
and press the rocker switch to the ON

– position

(I). To stop the compressor simply press to the
OFF-position (0). Turn the regulator until the
desired spray pattern is reached. It is advisable to
spray a small test area first especially if spraying
on top of another painted surface. Certain paints
and varnishes can react badly with finishes of
differing types.

7

OPERATING INSTRUCTIONS

For best results thoroughly clean the surface being painted. This should be free from dust and
grease. It is also advisable to protect the painted area from airborne dust particles.
To obtain the best results use the spray gun at a distance of 25-30 cm away from the surface
being sprayed. Several light coats rather then one thick coat will help prevent the paint running.
Allow each coat to dry slightly before re-applying.
Use long sweeping arm movements rather than short wrist movements to ensure the distance
between the work piece and the spray gun is kept constant. The most suitable method of
surface spraying is with a cross-pattern, starting with horizontal passes and finishing with light
vertical passes.

It may be necessary to mask the surrounding area of the work piece. This can be done using
tape and newspaper. For window panes a damp piece of newspaper stuck to the pane will
protect the glass for a short period.

Always remember to disconnect from the mains supply before filling the
paint container with sprayable material.

Most paints are supplied ready for brush application and will need to be thinned before they
are suitable to be sprayed. Follow the manufacturer’s advice on thinning. The paint when
used with a spray gun. The viscosity cup will help you to determine the correct viscosity of
paint to be used. To determine the correct viscosity, fill the cup to the brim with the paint.