Powerplus POW754 PAINT SPRAY GUN 600W EN - Manual (Page 5)

POW754 EN
Copyright © 2014 VARO P a g e | 5 www.varo.com
 Naked flames - never spray near a naked flame or appliance pilot flame.
 Smoking - never smoke whilst spraying.
 Thinning - always read the paint manufacturers thinning recommendations or instructions
before using paint or other materials.
 Disconnect from the nains supply - always disconnect from the mains supply when filling
the paint container or cleaning the spray gun.
 Switch off when not spraying – avoid running the unit with the flow rate knob fully closed
for any length of time.
We accept no responsibility for damage caused by the use of unsuitable
substances, or paints that have not been thinned correctly, and any health
hazards that arise from lack of adequate ventilation
5.1 Immediately switch off the spray gun when :
 Interruption in the mains plug, mains lead or mains lead damage.
 Defect switch.
 Smoke or stench of scorched isolation.
6 ASSEMBLY INSTRUCTIONS
Attach the spray gun storage tray to the side of the
compressor by sliding the square locating block
into the recess on the side of the compressor unit :
Attach one end of the flexible air
hose to the outlet on the compressor
unit
And the other end to the inlet on the spray gun :
Before carrying out any work it is necessary to
determine the consistency or viscosity of the paint
used.
This is measured in DIN-sec(onds). To determine
this, firstly thoroughly mix the paint. Immerse the
viscosity measuring cup in the paint below the
cups rim. Raise the cup and measure the time
take in seconds for the liquid to run out, this will
give a DIN-s value: (See viscosity table) - The
maximum viscosity for spraying with this spray gun
is 30 DIN-seconds.