Powerplus POW706 HEAT GUN 2000W EN - Manual (Page 7)

POW706
EN
Copyright © 2014 VARO P a g e | 7 www.varo.com
9.3 Stationary use
This tool can also be used in stationary mode.
 Place the tool onto the workbench.
 Secure the cable to prevent pulling the tool off the workbench.
 Carefully switch the tool on.
Make sure that the nozzle always points away from you and any
bystanders.
Make sure not to drop anything into the nozzle.
9.4 Cooling down
The nozzle and accessory become very hot during use. Let them cool down before attempting
to move or store the tool.
 To reduce the cooling time, switch the tool on at the lowest air temperature setting and let
in run for a few minutes.
 Switch the tool off and let it cool down for at least 30 minutes.
10 MAINTENANCE AND CLEANING
Attention !Before performing any work on the equipment, pull the power
plug.
10.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10.2 Lubrication
Your power tool requires no additional lubrication
11 TECHNICAL DATA
Rated Voltage 230 V
Rated frequency 50 Hz
Rated power 1350W/2000W
Protection class II
Air debit (capacity) 300/500 l/min
Max. temperature 300/600 °C
12 SERVICE DEPARTMENT
 Damaged switches must be replaced by our after-sales service department.
 If the connecting cable (or mains plug) is damaged, it must be replaced by a special
connecting cable which is available from our service department. Replacement of the
connecting cable should only be carried out by our service department (see last page) or
by a qualified specialist (qualified electrician).