Powerplus POW706 HEAT GUN 2000W EN - Manual (Page 4)

POW706
EN
Copyright © 2014 VARO P a g e | 4 www.varo.com
5.4 Power tool use and care
 Do not expect the power tool to do more than it can. Use the correct power tool for what
you want to do. A power tool will achieve better results and be safer if used in the context
for which it was designed.
 Do not use the power tool if the switch cannot turn it on and off. A power tool with a broken
switch is dangerous and must be repaired.
 Disconnect the plug from the power source before making adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
 Store power tools, when not in use, out of the reach of children and do not allow people
who are not familiar with the power tool or these instructions to operate it. Power tools are
potentially dangerous in the hands of untrained users.
 Maintenance. Check for misalignment or jammed moving parts, breakages or any other
feature that might affect the operation of the power tool. If it is damaged, the power tool
must be repaired. Many accidents are caused by using poorly maintained power tools.
 Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to jam and are easier to control.
 Use the power tool, accessories and cutting tools, etc., in accordance with these
instructions and in the manner intended for the particular type of power tool, taking into
account the working conditions and the work which needs to be done. Using a power tool
in ways for which it was not intended can lead to potentially hazardous situations.
5.5 Service
Your power tool should be serviced by a qualified specialist using only standard spare parts.
This will ensure that it meets the required safety standards.
6 ADDITIONAL SAFETY INSTRUCTIONS
 Do not place your hand over the air vents or block the vents in any way.
 The nozzle and accessories of this tool become extremely hot during use. Let these parts
cool down before touching.
 Always switch the tool off before putting it down.
 Do not leave the tool unattended while it is switched on.
 A fire may arise if the appliance is not used with care
 Heat may be conducted to combustible materials hat are out of sight.
 Do not use in a damp atmosphere, where flammable gases may be present or near
combustible materials.
 Allow the tool to cool fully before storing.
 Ensure adequate ventilation as toxic fumes may be produced.
 Do not use as a hairdryer.
 Do not obstruct either the air intake or nozzle outlet, as this may cause excessive heat
build up resulting in damage to the tool.
 Do not direct the hot air blast at other people.
 Do not touch the metal nozzle as it becomes very hot during use and remains hot for up to
30 minutes after use.
 Do not place the nozzle against anything while using or immediately after use.
 Do not poke anything down the nozzle as it could give you an electric shock. Do not look
down the nozzle while the unit is working because of the high temperatures being
produced.
 r scraper as it could ignite after some time.