Dismantling, Lubrication - oil level, Check or change of carbon brushes – Powerplus POW30580 DEMOLITION HAMMER 1600W EN User Manual

Page 7

POW30580

P a g e

| 7

www.varo.com

8.2

Dismantling

Proceed in reverse order to mounting

9 LUBRICATION - OIL LEVEL

Before completing the oil level, unplug the tool from the 230V network. The oil weir offers
autonomy of 20 days based on a continuous use of 3 hours a day. But check the oil level
every day. Just before the oil level is no longer visible in the gauge window (G) by holding the
tool vertically (the drive spindle downwards), proceed to filling the oil reservoir. Remove the oil
gauge (G) with the spanner supplied, watch out not to damage or loose the gasket. Fill the
reservoir with type #40 oil (motor oil) Place the gauge back.

10 CHECK OR CHANGE OF CARBON BRUSHES

These procedures are always done tool unplugged from the 230V network. Checking the
carbon brushes is advised after 50 hours of use of the tool. Remove the cover (J). Remove the
carbon-holder cap and remove the brush. The carbon part should be at least 5 mm long. In
case of wear or in case of forming of excessive sparks, imperatively change both brushes by
carbon brushes with identical characteristics.