beautypg.com

Application, Changing tools, Mounting – Powerplus POW30580 DEMOLITION HAMMER 1600W EN User Manual

Page 6

background image

POW30580

EN

Copyright © 2014 VARO

P a g e

| 6

www.varo.com

 Check damaged parts. Before further use of the tool, a guard or other part that is

damaged should be carefully checked to determine whether it will operate properly and
perform its intended function. Check for alignment of moving parts, free running of moving
parts, breakage of parts, mounting and any other conditions that may affect its operation.
A guard or other part that is damaged should be properly repaired or replaced by an
authorized service centre unless otherwise indicated in this instruction manual. Have
defective switches replaced by an authorized service centre. Do not use the tool if the
switch does not turn it on and off.

 Warning ! The use of any accessory or attachment, other than recommended in this

instruction manual, may present a risk of personal injury.

 Have your tool repaired by a qualified person. This electrical tool is in accordance with the

relevant safety requirements. Repairs should only be carried out by qualified persons
using original spare parts, otherwise this may result in considerable danger to the user.

7 APPLICATION

Before plugging in, make sure that the network's voltage and frequency correspond to those
indicated on the tool's ratings plate; and that the ON/OFF button did not remain blocked The
tool operates, or is in "ON" position, when the trigger (F) is pressed and comes back to the
"stop" position when the same trigger is released. Always hold the tool firmly with both hands,
with handles (A) and (B), while operating. It is sometimes necessary to apply force on the
point of the drill spindle so that the percussion system may operate otherwise the protection
device against off-load operating passes into action.
Adopt a moderate workload; the use of too much force alters safety and efficiency.

8 CHANGING TOOLS

Unplug the tool from the power supply, only use drill spindles compatible with the tool
(HITACHI type imprint)

8.1

Mounting

Clean the drill spindle before use and lightly oil the special imprint. Pull and turn the lock (C)
180° clockwise. Insert the drill spindle (D) in the hexagonal housing, the slot on the lock side.
Pull and turn lock (C) 180° anticlockwise. Pull the drill spindle to check that it can only have a
translation movement de translation of about 3cm.