Powerplus POW30546 HAMMER DRILL 1200W EN - Manual (Page 6)

POW30546 EN
Copyright © 2014 VARO NV P a g e | 6 www.varo.com
8.4 Dust collection device (Fig 6)
Before carrying out hammer-drilling work vertically overhead pull dust collecting device over
the drill bit.
8.5 Hammer stop
 Your hammer drill is equipped with a hammer stop facility for smooth drilling.
 To deactivate the hammer action, turn the lever switch clockwise to position.
 To reactivate the hammer action, the lever switch has to be reset to position.
8.6 Drill Stop (Fig 7)
You can deactivate the drilling action of the hammer drill when using it for chiselling work
 To do so, turn the lever selector so that the mark coincides with the arrow on the
machine case.
 To reactivate the drilling action, the lever selector has to be reset so that the mark
coincides with arrow.
Important! When hammer drilling you will require a low pressure. Too much
pressure will place unnecessary load on the motor. Check the drill bits
regularly. Re-sharpen or replace blunt drill bits.
9 CLEANING AND MAINTENANCE
 Remove the mains plug from the socket before carrying out any work on the device.
 Keep your machine clean at all times.
 Never use caustic agents to clean the plastic parts.
 At the end of your work, to prevent dust deposits you should use compressed air (max.3
bar) to clean out the ventilation slots.
 Check the carbon brushes regularly（dirty or worn carbon brushes result in excessive
sparking and speed faults）
Caution: Do not use cleaning agents to clean the plastic parts of the tool. A
mild detergent on a damp cloth is recommended. Water must never come
into contact with the tool.
10 TECHNICAL DATA
Rated Voltage 230-240 V
Rated Frequency 50 Hz
Rated Power 1200 W
Rotation speed 850 min
-1
Protection class II
Drill capacity concrete 26 mm
Drill capacity steel 13 mm
Drill capacity wood 40 mm
Impact rate 4100 min
-1
Cable length 2 m + VDE plug
Chuck type 13 mm key chuck