Powerplus POW30546 HAMMER DRILL 1200W EN - Manual (Page 5)

POW30546 EN
Copyright © 2014 VARO NV P a g e | 5 www.varo.com

Chisel bits and drill bits may be flung out of the machine accidentally and cause serious
injury:

Before starting to work, always check that the chisel or drill bit is properly locked in the
chuck.

Never start up a hammer tool until it is pressed against a workplace (wall, ceiling, etc.).

When you are finished, unplug the hammer drill from the electric supply and remove the
chisel or drill bit from the machine.

Always disconnect the hammer drill from the electric supply before you change a chisel or
drill bit.
 Protect your eyes and other workers from flying particles and splinters. Wear a helmet! Set
up partition walls!
 Wear work gloves to protect fingers from bruising and grazing.
 Vibrations can injure the hand-arm system. Keep exposure to vibrations as short as
possible.
 Always lead the mains cable away backwards from the device
 Store the device where it is inaccessible to children.
 When carrying out work, always hold the device with both hands and ensure that you have
a stable standing position.
7 BEFORE STARTING WORK
 Examine the place where the device is to be used for hidden electrical cables, gas and
water pipes using a pipe finding device.
 Before connecting to !he mains, ensure care that the mains voltage corresponds to the
details on the rating plate.
7.1 Fitting and changing tools (Fig 2)
The device is equipped with a SDS-plus attachment system.
 Clean tools and grease with a thin layer of machine grease before fitting.
 Pull back fastening sleeve and hold.
 Push and rotate the dust-free tool into the tool holder as far as it will go, The tool will lock
automatically.
 Check that it has locked by pulling the tool
7.2 Removing SDS-plus tool (Fig 3)
Pull back fastening sleeve, hold and remove tool.
8 STARTING WORK
8.1 Switching ON/OFF
 Switching on: Press the operating switch.
 Switching off: Press the operating switch briefly and let go.
8.2 Handle attachment (Fig 4)
For reasons of safety, only use the hammer drill with handle attachment.
You will be able to obtain a safe body position when working by rotating the handle attachment.
Loosen and turn the handle attachment in an anti-clockwise direction: Then tighten the handle
attachment.
8.3 Depth stop (Fig 5)
Loosen the handle attachment and place the straight part of the depth stop in the hole. Adjust
the depth stop and retighten the handle attachment.