Powerplus POW2087 ANGLE GRINDER 2150W 230MM EN - Manual (Page 7)

POW2087 EN
Copyright © 2013 VARO P a g e | 7 www.varo.com
7.2 Mounting a grinding disc (Fig. C)
Use grinding discs of the correct dimension. Use fibre-reinforced grinding discs only. The
grinding disc must not touch the edge of the guard.
 Press the spindle lock and turn the spindle (9) until it engages in the lock. Keep the
spindle lock pressed during this procedure.
 Retrieve the flange nut (12) from the spindle using the spanner (11).
 Position the grinding disc (7) on the flange (5).
 Place the flange nut on the spindle an tighten using the spanner.
 Release the spindle lock and check that the spindle is unlocked by rotating it.
7.3 Mounting the side handle
The side handle can be used for both left-hand and right-hand control.
 Fasten the side handle for left-hand operation on the right-hand side of the machine.
 Fasten the side handle for right-hand operation on the left-hand side of the machine.
 Fasten the side handle for upright working at the top of the machine.
Make sure that the side handle is fastened propperly and cannot loosen
unexpectedly.
8 OPERATION
Do not place the machine on the workpiece when switching the machine on or off. The
grinding disc may damage the workpiece.
 Clamp the workpiece and make sure that the workpiece cannot slide from under the
machine during the cutting activities.
 Hold the machine firmly and press it under an angle of approximately 15' against the
workpiece. Move the grinding disc evenly across the workpiece.
 Regularly inspect the grinding disc. Worn grinding discs have a negative effect on the
efficiency of the machine. Replace a grinding disc on time.
 Always switch off the machine first before removing the plug from the wall socket.
8.1 Switching on / off
Attention! Before working with the angle grinder, check that the voltage
shown on the machine’s model plate is the same as the mains voltage
being used. Before engage the ON/OFF switch trigger, check that the
grinding disc is properly fitted and run smoothly, the outer flange is well
tightened.
8.1.1 Switching on (Fig. D)
 Insert the plug into a correctly installed mains socket.
 Push forward the ON / OFF switch with safety button (5) (See the arrow (1) on Fig. 10),
and at the same time depress it firmly inwards and keep it pressed (See the arrow (2)).