Powerplus POW2087 ANGLE GRINDER 2150W 230MM EN - Manual (Page 6)

POW2087 EN
Copyright © 2013 VARO P a g e | 6 www.varo.com
 Make sure that the grinding disc has been mounted and fastened property. Do not use
reducing rings or adapters to make the grinding disc fit property.
 Treat and store grinding discs in conformance with the supplier's instructions.
 Do not use the machine for grinding workpieces with a maximum thickness exceeding the
maximum grinding depth of the grinding disc.
 Do not use grinding discs for deburring.
 When grinding discs have to be mounted on the thread of the spindle, make suree that the
spindle has sufficient thread. Make sure that the spindle is sufficiently protected and does
not touch the grinding surface.
 Before use, inspect the grinding disc for any damage. Do not use grinding discs which are
cracked ripped or otherwise damaged.
 Before use let the machine run idle for 30 seconds immediately switch off the machine in
case of abnormal vibrations or occurrence of another defect. Carefully inspect the
machine and grinding disc before switching the machine on again.
 Make sure that sparks do not put people into danger or that they contact highly flammable
substances.
 Make sure that the workpiece is sufficiently supported or clamped. Keep your hands away
from the surface to be cut.
 Always wear safety goggles and hearing protection. If desired or required also use another
kind of protection like for example an apton or helmet.
 Ensure that mounted wheels and points are fitted in accordance with the manufacturers
instructions.
 Ensure that blotters are used when they are provided with the bonded abrasive product
and when they are required.
 If a guard is supplied with the tool never use the tool without such a guard.
 For tools intended to be fitted with threaded hole wheel, ensure that the thread in the
wheel is long enough to accept the spindle length.
 Ensure that ventilation openings are kept clear when working in dusty conditions. If it
should become necessary to clear dust, first disconnect the tool from the mains supply
(use non metallic objects) and avoid damaging internal parts.
 Though poor conditions of the electrical mains, shortly voltage drops can appear when
starting the equipment. This can influence other equipment (eq. blinking of a lamp). lf the
mains impedance Zmax <0,348 Ohm such disturbances are not expected. (in case of
need, you may contact your local supply authority for further information).
7 MOUNTING ACCESSORIES (FIG. B)
Prior to mounting an accessory always unplug the tool.
7.1 Assembly the protective guard
 Loosen the clip of the safety guard (9) by pulling lock lever of protective guard (1) outward.
 Turn the protective guard so that uncovered part of the disc is as far apart as possible
from the hand on main handle (4).
 Fix the protection guard by pushing the lock lever inwards (the protective guard should no
longer be able to move).
NOTE: If the protective guard can not be fixed firmly by the lock lever (1),
use a hexagon wrench to tighten the hexagon nut. (See attached figure 4)