Powerplus POW222 WALL SLOTTER 1700W EN - Manual (Page 7)

POW222
EN
Copyright © 2013 VARO P a g e | 7 www.varo.com
11 OPERATION
Mark the line of cut before starting work, hold the machine tightly with both
hands.
Fig
11
 Set the chase depth, press the front edge of the
depth stop, firmly against the wall. Switch the
machine on and gently lower the machine towards
the wall until the rotating diamond cutting discs
plunge into the wall ,Hold the machine tightly with
both hands.
 Carry out the cut steadily, evenly and with moderate
pressure appropriate to the material being cut.
Ensure you work in the correct direction! Always work
against the direction of rotation as shown on the
machine’s protective guard to avoid the risk of the
machine being forced uncontrolled of the cut.
 After completing the retract the machine slightly,
switch off and remove from the cut.
12 MAINTENANCE
Disconnect the unit from the mains before carrying out any maintenance or
adjustments.
The machine requires very little maintenance.
 Ensure that the ventilation slots are not blocked and clean the machine regularly with a
soft cloth, clean the ventilation slots using a vacuum cleaner.
 Mains cables and carbon brushes may only be replaced by our technical department.
 Remove the diamond cutting discs and clean the motor flange, the flange nut and the
protective guard after finishing work.
 Carefully check the diamond cutting discs for signs of damage such as broken segments
etc.
 Damaged cutting discs must be replaced immediately.
 In case of a breakdown, have the machine repaired by our technical department.
13 TECHNICAL DATA
Nominal Voltage 230-240V ~ 50 Hz
Power rating 1700W
No load speed 4000min
-1
Max. cutting depth 10
– 40 mm
Channel width 14 / 19 / 29 mm
Weight 4.7 kg
Cutting disc (x2) Ø 150 x Ø 22.2 mm
Degree of protection IP20
Insulation class II