Powerplus POW222 WALL SLOTTER 1700W EN - Manual (Page 5)

POW222
EN
Copyright © 2013 VARO P a g e | 5 www.varo.com
6 FITTING /CHANGING THE DIAMOND CUTTING DISCS
Fig 2
 Place the machine on a stable workbench.
 Remove screws using the Hex key.
 Remove the fixing screw(4) (Do not lose the
washers and spring washers)
 Remove the protective guard and swivel the
depth stop(6) downwards.
 Press the spindle lock button(12) and loosen the
flange nut using the pin spanner. Remove the
diamond cutting discs and the spacer rings.
 Place one diamond cutting disc onto the motor
flange.
 Slide space rings (as required) followed by the
remaining diamond cutting disc on the spindle.
 Press the spindle lock button(12) and screw the
flange nut onto the spindle using the pin spanner.
 Rotate the depth stop upwards, and replace the
depth stop
 Put screws back in place using the hex key.
(Caution! Do not forget the washer and lock
washers replace the depth stop fixing screw)
Fig 3
Fig 4
Caution! Always replace diamond cutting discs in pairs. To loosen /
tighten discs: Press spindle lock button, turn disc by hand until it locks,
then loosen / tighten with pin spanner.
7 DEPTH ADJUSTMENT
Fig5
 Loosen the fixing screw for depth stop (4)and set
the require depth.
 Re-tighten the fixing screw for depth stop select
a chase depth approximately 3mm deeper that
the actual required depth to compensate for
unevenness in the wall surface.
8 TURNING THE MACHINE ON/OFF
Fig 6
 Press the safety switch (10) and pull the trigger(3) ,the
machine is on.
 Release the trigger ,the machine is off.
 The machine fitted with a soft start mechanism
 The machine has an overload protection device. In case
of overload, it will shut down automatically. Release the
trigger and remove the machine from the work-piece.
Allow to cool for a few minutes, then restart and run the
machine at no-load for approximately one minute to cool
the machine down faster.