Powerplus POWXQG4040 CHAINSAW 2400W 405MM EN - Manual (Page 16)

POWXQG4040
EN
Copyright © 2014 VARO P a g e | 16 www.varo.com
WARNING! Only sharpen the saw chain yourself if you are trained and have
experience! Use proper tools to sharpen the saw chain!
12 TROUBLESHOOTING
Problem Possible cause Solution
Product does not start Not connected to power
supply Connect to power supply
Power cord or plug is
defective Check by a specialist electrician
Other electrical defect to the
product Check by a specialist electrician
Overload protection is
actuated Switch the product off and let it cool
down, then restart
Product does not
reach full power Extension cord not suitable
for operation with this
product Use a proper extension cord
Power source (e.g.
generator) has too low
voltage Connect to another power source
Air vents are blocked Clean the air vents
Unsatisfactory cutting
performance Saw chain not tensioned
properly Tension properly
Blunt saw chain Sharpen or replace the saw chain
paying attention to the maximum
allowed length
13 TECHNICAL DATA
Type POWXQG4040
Rated voltage/frequency 230-240V~ 50Hz
Rated power 2400W
Bar length
16” (405mm)
No load chain speed 13.5m/s
Tank capacity of lubricating oil 230 ml
Protection class II
Weight 5.0 kg
14 NOISE
Noise values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
85 dB(A)
Acoustic power level LwA 107 dB(A)
ATTENTION! The sound power level may exceed 85 dB(A), in this case
individual hearing protection shall be worn.
aw (Vibration) 3.8 m/s² K = 1,5 m/s²