Powerplus POWXQ6104 HEAT GUN 2000W EN - Manual (Page 9)

POWXQ6104/POWXQ6110
EN
Copyright © 2011 VARO NV P a g e | 9 www.varo.com
Avoid collecting paint on the scraper accessory, as it may ignite. If
necessary, carefully remove paint debris from the scraper accessory using
a knife.
8.4 Stationary use
This tool can also be used in stationary mode.
Secure the cable to prevent pulling the tool off the workbench.
Carefully switch the tool on.
Make sure that the nozzle always points away from you and any
bystanders.
Make sure not to drop anything into the nozzle.
8.5 Cooling down
The nozzle and accessory become very hot during use. Let them cool down before attempting
to move or store the tool.
To reduce the cooling time, set the on/off switch to position 1 which is the cool-down
position, set the tool at the lowest air temperature and max. air flow,
and let in run for a
few minutes.
Switch the tool off and let it cool down for at least 30 minutes.
9 MAINTENANCE AND CLEANING
Attention! Before performing any work on the equipment, pull the power
plug.
9.1 Maintenance
Your Power Tool has been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper tool care and regular
cleaning.
9.2 Lubrication
Your power tool requires no additional lubrication.
9.3 Cleaning
Regularly clean the housing with a soft cloth.
Keep the ventilation slots of the machine clear/clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.