beautypg.com

7 assembly and adjustment – Powerplus POWXQ6104 HEAT GUN 2000W EN User Manual

Page 6

background image

POWXQ6104/POWXQ6110

EN

Copyright © 2011 VARO NV

P a g e

| 6

www.varo.com

7 ASSEMBLY AND ADJUSTMENT

Prior to assembly and adjustment always unplug the tool.

The air temperature can be adjusted to suit a wide range of applications. The table below
suggests settings for different applications.
Setting

Applications

1
(50° C)

Drying paint and varnish, colour shade samples, filler, adhesives,
construction joints and stucco forms.

Drying wet timber prior to filling.

Removing stickers.

Joining adhesives. Large-surface gluing with contact adhesives,
activation of pressure-sensitive adhesives, acceleration of bonding
processes, releasing of bonding points as well as releasing or
bonding of edge band or veneer.

Waxing and de-waxing.

Shrinking PVC wrapping and insulation tubes.

Warning ! this operation must not be repeated on a fitting since this
can result in live parts becoming accessible.

Defrosting of icy stairs and steps, door locks, trunk lids, car doors or
water pipes, as well as for defrosting refrigerators and ice boxes.

2
(POWXQ6104

-

400°C)
(POWXQ6110 –
adjusted temp)

Welding of thermoplastics polymer, flooring materials of PVC and
linoleum, PVC-coated fabric, tarpaulins and foils.

Bending plastic pipes and sheets.

Soldering plumbing joints, tin, special silver solder, SMD elements,
cable lugs.

Loosening rusted or tightly fastened nuts and bolts.

Removing old and even thick coatings of oil paint, lacquer, varnish
and synthetic plaster.

3 (POWXQ6104:
- 600°C)
2 (POWXQ6110–
adjusted to high
(max 650°C))

Disinfection with hot air of 600°C, you can quickl y get rid of bacteria.
(Caution: Danger of fire! Do not heat up the wooden surface
excessively
).

If you are not sure about the correct setting, start with a low temperature
setting and gradually increase the temperature until you achieve optimum
results.

This manual is related to the following products: