Powerplus POWXQ5226 HAMMER DRILL 1250W EN - Manual (Page 5)

POWXQ5226 EN
Copyright © 2014 VARO P a g e | 5 www.varo.com
 Do not reach out too far. Keep your feet firmly on the ground at all times. This will enable
you retain control over the power tool in unexpected situations.

Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and
gloves away from the power tool. Loose clothes, jewellery or long hair can become
entangled in the moving parts.
 If there are devices for connecting dust extraction and collection facilities, please ensure
that they are attached and used correctly. Using such devices can reduce dust-related
hazards.
5.4 Power tool use and care
 Do not expect the power tool to do more than it can. Use the correct power tool for what
you want to do. A power tool will achieve better results and be safer if used in the context
for which it was designed.

Do not use the power tool if the switch cannot turn it on and off. A power tool with a
broken switch is dangerous and must be repaired.
 Disconnect the plug from the power source before making adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
 Store power tools, when not in use, out of the reach of children and do not allow people
who are not familiar with the power tool or these instructions to operate it. Power tools are
potentially dangerous in the hands of untrained users.
 Maintain power tools. Check for misalignment or jammed moving parts, breakages or any
other feature that might affect the operation of the power tool. If it is damaged, the power
tool must be repaired. Many accidents are caused by using poorly maintained power
tools.
 Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to jam and are easier to control.
 Use the power tool, accessories and cutting tools, etc., in accordance with these
instructions and in the manner intended for the particular type of power tool, taking into
account the working conditions and the work which needs to be done. Using a power tool
in ways for which it was not intended can lead to potentially hazardous situations.
5.5 Service

Your power tool should be serviced by a qualified specialist using only standard spare
parts. This will ensure that it meets the required safety standards.
6 ADDITIONAL SAFETY INSTRUCTIONS
 Use the auxiliary handle that is supplied with the tool.
 Use clamps or a vice to hold the work piece.
 Do not put pressure on the drill such that slows the motor down. Allow the drill bit to cut
with pressure. You will get better results and you will be taking better care of the tool.
 Do not touch the bit after operation. It will be very hot.
 Only use accessory bits in good condition.

Keep your hands away from under the work piece.

Periodically check that all nuts, screws and other fixings are properly tightened.
 Fully unwind extension leads to avoid potential overheating.
 When the drill or chisel is blocked, you have to release the trigger switch immediately. If
not, the motor will get burned or damaged will be done. This will not be warranty!